Keeps you coolant temperature under control.
Independent economic system for coolant cooling.
ELITE model FILTRAmaq AIR mini
Keep you coolant temperature at a stable desired temperature, valid for emulsion and oil.
FILTRAmaq AIR mini let’s you keep your coolant temperature stable and low, thus saving grinding wheel wear and optimizing the coolant use. But the most important function it’s to keep the machine temperature stable so as the tolerance of the tools.
Always on the run
With centralized filtration systems, if the system breaks down the machines which depend on stop working. FILTRAmaq AIR operates autonomously to the attached machine by its own pump.
Portable
Everything what you need it’s inside.
As a small system it is also portable, so if you need to move it to another machine or use it as and auxiliary cooler system, it is very easy to do.
Welcome to ecology
Together with our grinding oil SintoCut PRO MD, you will no longer have to throw the burned oil.
You use a synthetic transparent oil such as SintoCut PRO MD, and even fine filtering it you get a toasted colour, that is because it gets too hot and the additives on the oil get burn. Properly cooling it will allow you that you will never have to throw out the oil.
No problem
Very easy to use: with its small LCD control panel you can control the desired temperature.
The microprocessor controlled temperature control will guarantee a high accuracy on the output coolant.
Plug and play!
It is very easy to set up, introduce the two tubes in your machine tank for the input and output of the coolant, connect the FILTRAmaq AIR mini to 220V. plug and you can switch it on.
FILTRAmaq AIR mini
- Cooling capacity: 5 kW.
- Flow rate 15 l/min.
- Coolant must be properly filtered before refrigerating
- Recommended maximum viscosity of oil: 10 cSt.
FILTRAmaq AIR mini | |
---|---|
Flow rate | 15 liters/minute |
Cooling temperature | 15ºC to 20ºC |
Working temperature | 10ºC to 43ºC |
Size | 990x970x355 mm. (L x W x H) |
Connected load | 2 kW |
Net weight | 85 Kg. |