Keeps you coolant at the desired temperature.
Independent system for coolant cooling.
ELITE model FILTRAmaq AIR
Keep you coolant temperature at a stable desired temperature, valid for emulsion and oil.
FILTRAmaq AIR let’s you keep your coolant temperature stable and low, thus saving grinding wheel wear and optimizing the coolant use. But the most important function it’s to keep the machine temperature stable so as the tolerance of the tools.
Always on the run
With centralized filtration systems, if the system breaks down the machines which depend on stop working. FILTRAmaq AIR operates autonomously to the attached machine by its own pump.
Welcome to ecology
Together with our grinding oil SintoCut PRO MD, you will no longer have to throw the burned oil.
You use a synthetic transparent oil such as SintoCut PRO MD, and even fine filtering it you get a toasted colour, that is because it gets too hot and the additives on the oil get burn. Properly cooling it will allow you that you will never have to throw out the oil.
Very easy to use: with its small LCD control panel you can control the desired temperature.
The microprocessor controlled temperature control will guarantee a high accuracy on the output coolant.
Plug and play!
It is very easy to set up, introduce the two tubes in your machine tank for the input and output of the coolant, connect the FILTRAmaq AIR to 220V. plug and you can switch it on.
- Cooling capacity: 10,5 kW.
- Flow rate 30 l/min.
- Coolant must be properly filtered before refrigerating
- Recommended maximum viscosity of oil: 10 cSt.
|Flow rate||30 liters/minute|
|Cooling temperature||15ºC to 20ºC|
|Working temperature||10ºC to 43ºC|
|Size||950x1250x360 mm. (L x W x H)|
|Connected load||3,7 kW|
|Net weight||140 Kg.|