You’ll never work without it.
Everyone should have a dielectric oil always in perfect condition, it is now possible.
ELITE model FILTRAmaq ERO
0,2 µm filtration for a dielectric in a perfect condition, always.
FILTRAmaq ERO was designed exclusively for the electro-erosion machines where any little imperfection in the dielectric used decreases machining time and surface quality dramatically.
The cost per hour of work in erosion machines is very high and the current filtration systems are not effective enough to remove all particles, until now: filtration to 0.2 microns.
Always on the run
With centralized filtration systems, if the system breaks down the machines which depend on stop working. FILTRAmaq ERO operates autonomously to the attached electro-erosion machine.
0,2 µm filtration
Filters particles so small that your dielectric comes back to live again, you can appreciate this in the color change experienced on the oil.
Always the highest quality
The same quality of filtration at the beginning and the end of the life of the filter cartridge.
Very easy to use: only incorporates a filter change indicator and on / off switch.
Focused on erosion machines
Does not matter if your machine works with dielectric oil or water. FILTRAmaq ERO filters it the same way to be the perfect choice always.
Plug and play!
It is very easy to set up, introduce the two tubes in your machine tank for the input and output of the dielectric, connect the FILTRAmaq ERO to 220V. plug and you can switch it on.
- Filtration quality: 0,2 µm.
- Flow rate 6 l/min.
- Lifetime of filter cartridge: up to 6 Kg.
- Recommended maximum viscosity of dielectric oil: 3 cSt.
|Flow rate||6 liters/minute|
|Filtration quality||particles of 0,2 µm and beyond|
|Size||466x382x615 mm. (L x W x H)|
|Connected load||0,4 kW|
|Net weight||60 Kg.|